7/13
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810404
A-2810404
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375201
For “Commander Wide Track” and “Commander Trek” Track Kit
MOUNTING INSTRUCTIONS
7
“COMMANDER WIDE TRACK”
FRONT ANTI-ROTATION INSTALLATION
(see sketch F)
1)
Assemble the free extremity of the front anti-rotation
(#
5
) to the hole made for this purpose in the plastic
frame of the Track Kit using the
3/8” nc X 3-3/4”
hex bolt
(#
10
), the
3/8” dia
flat washer (#
9
), the tightening
spacer (#
3
), the neoprene flat washer (#
18
), the
(2)
3/8” I.D. X 1-1/4” O.D. X .120”
Fender washers (#
16
), and
the
3/8” nc
self-locking nut (#
13
).
Apply a tightening torque of 23 ft-lbs.
WARNING :
Attention, many holes are available
on the anti-rotation fixation plate. Take the one
which will make so that the track kit is correctly
in contact with the ground.
2)
Repeat
step 1
for the opposite side.
NOTE:
Refer to the track kit manual to complete
the installation.
“COMMANDER TREK”
FRONT ANTI-ROTATION INSTALLATION
(see sketch G)
1)
Remove the wheel cap (#
A
).
2)
Assemble the free extremity of the front anti-rotation
(#
5
) to the hole made for this purpose in the frame of
the Track Kit using the
3/8” nc X 3-3/4”
hex bolt (#
10
), the
3/8” dia
flat washer (#
9
), the tightening spacer (#
3
), the
neoprene flat washer (#
18
), and the
3/8” nc
self-locking
nut (#
13
).
Apply a tightening torque of 23 ft-lbs.
WARNING :
Attention, many holes are available
on the anti-rotation fixation plate. Take the one
which will make so that the track kit is correctly
in contact with the ground.
3)
Reinstall the wheel cap (#
A
) removed in
step 1
.
4)
Repeat
steps 1
to
3
for the opposite side.
NOTE:
Refer to the track kit manual to complete
the installation.
sketch F
LEFT
FRONT VIEW
Front of the ATV
sketch G
LEFT
FRONT VIEW
Front of the ATV
