12/13
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810404
A-2810404
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375201
For “Commander Wide Track” and “Commander Trek” Track Kit
MOUNTING INSTRUCTIONS
12
sketch Q
RIGHT
REAR VIEW
Rear of
the ATV
“COMMANDER TREK”
REAR ANTI-ROTATION INSTALLATION
(see sketch Q)
1)
Screw the
5/8” nc
nut (#
15
) onto the threaded part of the anti-
rotation arm (#
4
).
2)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer (#
21
) and the
bushing spacer tube (#
2
) onto the threaded part of the anti-
rotation arm (#
4
).
3)
Install the rubber bushing (#
1
) over the bushing spacer tube
(#
2
).
4)
Slide the anti-rotation arm assembly into the hole of the rear
right anti-rotation arm bracket (#
24
).
(see sketch R)
5)
Fasten the other end of the rear anti-rotation arm (#
4
) onto the
rear anti-rotation arm support (#
6
) installed in
step 1 at the
“SNOWPLOW ADAPTER INSTALLATION” section
using the
3/8” nc X 3”
hex bolt (#
12
) and the
3/8” nc
self-locking nut (#
18
).
(see sketch Q)
6)
Install the rubber bushing (#
1
), the
3/4” I.D. X 2” O.D. X 1/8”
flat washer (#
20
), and the other rubber bushing (#
1
) over the bushing spacer
tube (#
2
).
7)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer (#
21
) onto the threaded part of the anti-rotation arm (#
4
).
8)
Screw the
5/8” nc
self-locking nut (#
19
) onto the threaded part of the anti-rotation arm (#
4
). Do not overtighten.
NOTE :
Refer to the Track Kit manual to complete the installation.
9)
Repeat
steps 1
to
8
for the opposite side.
sketch R
Rear of the ATV
