11/11
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810418
A-2810418
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375121
For Commander WIDE TRACK, WTX, and TREX Track Kits
MOUNTING INSTRUCTIONS
11
(see sketch Q)
6)
Fasten the other end of the rear anti-rotation arm (#
9
) onto the
mount plate (#
8
) installed in the
“MOUNT PLATE
INSTALLATION” section
using a
3/8” nc X 1-3/4”
hex bolt (#
13
),
a
3/8” dia
flat washer (#
20
), a
.3965” I.D. X 9/16” O.D. X .44”
tightening
spacer (#
11
), the neoprene flat washer (#
6
), an other
3/8” dia
flat
washer (#
20
), and a
3/8” nc
self-locking nut (#
17
).
IMPORTANT:
The neoprene flat washer (#
6
) must be installed
between the anti-rotation arm (#
9
) and the mount plate (#
8
).
(see sketch R)
7)
Install the rubber bushing (#
1
), the
3/4” I.D. X 2” O.D. X 1/8”
flat
washer (#
21
), and the other rubber bushing (#
1
) over the
bushing spacer tube (#
2
).
8)
Install the
17 mm I.D. X 50 mm O.D. X 3 mm
flat washer (#
7
) onto the
threaded part of the anti-rotation arm (#
9
).
9)
Screw the
5/8” nc
self-locking nut (#
18
) onto the threaded part
of the anti-rotation arm (#
9
). Do not overtighten.
NOTE:
Refer to the Track Kit manual for the correct
adjustment.
10)
Repeat
steps 1
to
9
for the opposite side.
sketch Q
RIGHT
REAR VIEW
Rear of
the ATV
sketch R
Rear of
the ATV
RIGHT
REAR VIEW
