KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810238
2810238
8/9
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 373719
For "Commander Wide Track" and " Commander trek Track kit
Yamaha Grizzly 660 2007-2008
REAR SUB-TABLE INSTALLATION
(see sketch G)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the rear left CV shield. Do not discard. They will be
reinstalled later.
3)
Install the
(2) 1/2” nc X 3”
hex bolts (#
16
) into the intended
mounting holes of the internal part of the rear left sub-table
plate (#
1
).
4)
Place the rear sub-table plate (#
1
) below the rear lower a-arm.
Install the rear left tightening plate (#
17
) on the top of the rear
lower a-arm and fasten using the
(2) 1/2” nc
self-locking nuts
(#
15
) (screw the first threads only).
5)
Install the
(3) 3/8” nc X 2-1/2”
hex bolts (#
14
) and the
(3) 3/8” dia
flat
washers (#
7
) over the rear lower a-arm into the intended
mounting holes of the rear sub-table plate (#
1
). Install
(3) 3/8” dia
flat washers (#
7
) and the
(3) 3/8” nc
self-locking nuts (#
12
).
6)
Tighten all the bolts. Torque the
1/2” nc
nuts (#
15
) to 55 ft-lbs and
the
3/8” nc
nuts (#
12
) to 20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
sketch G
LEFT
REAR VIEW
Rear of the ATV
