6/11
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810413
A-2810413 Rev. A
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375229
For Commander Wide Track, WTX, and TREX Track Kits
MOUNTING INSTRUCTIONS
6
FRONT ANTI-ROTATION INSTALLATION
(see sketch E)
NOTE:
Pay special attention to the orientation given to spacers (#3 and #4) during installation.
1)
Assemble the ball joint (#
16
) and the
1/2” nf
nut (#
15
) to the front anti-rotation assembly (#
11
)
.
2)
Install the large ball joint spacer (#
4
) with the narrow part facing down onto the
1/2” nc X 2-1/2”
carriage bolt (#
9
) installed in
step 3 of
the “FRONT A-ARM BRACKET INSTALLATION” section.
3)
Install the ball joint of the anti-rotation assembly (#
11
) onto the bolt (#
9
), below the large ball joint spacer (#
4
). Install the short ball joint
spacer (#
3
) with the narrow part facing up, below the anti-rotation assembly (#
11
).
4)
Tighten the assembly with the
1/2” nc
self-locking nut (#
8
). Torque to 55 ft-lbs.
WARNING:
If the bolts are not sufficiently tightened, there is a risk of them becoming loose, of parts detaching and risk
of loss of control over the vehicle, as well as risk of personal injury.
5)
Rotate the anti-rotation assembly (#
11
) towards the center of the ATV to prevent it from interfering with the installation of the track kit.
NOTE:
Refer to the Track Kit manual to complete the installation.
6)
Repeat
steps 1
to
5
for the opposite side.
sketch E
LEFT
FRONT VIEW
Front of the ATV
