7/11
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810413
A-2810413 Rev. A
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375229
For Commander Wide Track, WTX, and TREX Track Kits
MOUNTING INSTRUCTIONS
7
COMMANDER WIDE TRACK AND WTX
FRONT ANTI-ROTATION INSTALLATION
(see sketch F)
1)
Assemble the free extremity of the front anti-rotation
(#
11
) to the hole made for this purpose in the plastic
frame of the Track Kit using the
3/8” nc X 3-3/4”
hex bolt
(#
6
), the
3/8” dia
flat washer (#
18
), the tightening
spacer (#
10
), the neoprene flat washer (#
17
), the
(2)
3/8” I.D. X 1-1/4” O.D. X .120”
Fender washers (#
5
), and the
3/8” nc
self-locking nut (#
2
).
Apply a tightening torque of 23 ft-lbs.
WARNING :
Attention, many holes are available
on the anti-rotation fixation plate. Take the one
which will make so that the track kit is correctly
in contact with the ground.
2)
Repeat
step 1
for the opposite side.
NOTE:
Refer to the Track Kit manual to complete
the installation.
COMMANDER TREX
FRONT ANTI-ROTATION INSTALLATION
(see sketch G)
1)
Remove the wheel cap (#
A
).
2)
Assemble the free extremity of the front anti-rotation
(#
11
) to the hole made for this purpose in the frame
of the Track Kit using the
3/8” nc X 3-3/4”
hex bolt (#
6
),
the
3/8” dia
flat washer (#
18
), the tightening spacer
(#
10
), the neoprene flat washer (#
17
), and the
3/8” nc
self-locking nut (#
2
).
Apply a tightening torque of 23 ft-lbs.
WARNING:
Attention, many holes are available
on the anti-rotation fixation plate. Take the one
which will make so that the track kit is correctly
in contact with the ground.
3)
Reinstall the wheel cap (#
A
) removed in
step 1
.
4)
Repeat
steps 1
to
3
for the opposite side.
NOTE:
Refer to the Track Kit manual to complete
the installation.
sketch F
LEFT
FRONT VIEW
Front of the ATV
sketch G
LEFT
FRONT VIEW
Front of the ATV
