Fix Kit And Replacement Parts Section - page 745

KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810339
2810339
9/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375228
For "Commander Wide Track" and "Commander Trek" track kit Kymco 500
“COMMANDER WIDE TRACK”
REAR ANTI-ROTATION INSTALLATION
(see sketch M)
WARNING :
Prior to installation, turn off
the engine, put in two-wheel driving mode
and the transmission in neutral, and block
the wheels.
1)
Raise the rear of the ATV off the ground and
remove the wheels.
WARNING :
When the ATV is raised, make
sure that it is properly secured/supported to
prevent it from accidentally falling during the
installation. If not properly secured/
supported, serious physical injury could occur.
2)
Screw the
5/8” nc
nut (#
19
) onto the threaded
part of the anti-rotation arm (#
10
).
3)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer
(#
26
) and the bushing spacer tube (#
2
) onto the
threaded part of the anti-rotation arm (#
10
).
4)
Install the rubber bushing (#
1
) over the bushing
spacer tube (#
2
).
5)
Slide the anti-rotation arm assembly into the hole
of the rear right anti-rotation arm bracket (#
7
).
(see sketch N)
6)
Fasten the other end of the rear anti-rotation arm
(#
10
) onto the rear anti-rotation arm support
(#
6
) installed in
step 2 at the “SNOWPLOW
ADAPTER INSTALLATION”
using the
3/8” nc X 3”
hex bolt (#
16
) and the
3/8” nc
nylock nut (#
22
).
(see sketch M)
7)
Install the rubber bushing (#
1
), the
3/4” I.D. X 2”
O.D. X 1/8”
flat washer (#
25
), and the other rubber
bushing (#
1
) over the bushing spacer tube (#
2
).
8)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer
(#
26
) onto the threaded part of the anti-rotation
arm (#
10
).
9)
Screw the
5/8” nc
self-locking nut (#
23
) onto the
threaded part of the anti-rotation arm (#
10
). Do
not overtighten.
NOTE :
Refer to the Track Kit manual to
complete the installation.
10)
Repeat
steps 2
to
9
for the opposite side.
sketch M
RIGHT
REAR VIEW
Rear of the ATV
6
22
10
16
sketch N
Rear of the ATV
1...,735,736,737,738,739,740,741,742,743,744 746,747,748,749,750,751,752,753,754,755,...1407
Powered by FlippingBook