KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810339
2810339
11/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375228
For "Commander Wide Track" and "Commander Trek" track kit Kymco 500
“COMMANDER TREK”
REAR ANTI-ROTATION INSTALLATION
(see sketch Q)
1)
Screw the
5/8” nc
nut (#
19
) onto the threaded part of the anti-
rotation arm (#
10
).
2)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer (#
26
) and the
bushing spacer tube (#
2
) onto the threaded part of the anti-
rotation arm (#
10
).
3)
Install the rubber bushing (#
1
) over the bushing spacer tube
(#
2
).
4)
Slide the anti-rotation arm assembly into the hole of the rear
right anti-rotation arm bracket (#
11
).
(see sketch R)
5)
Fasten the other end of the rear anti-rotation arm (#
10
) onto the
rear anti-rotation arm support (#
6
) installed in
step 1 at the
“SNOWPLOW ADAPTER INSTALLATION” section
using the
3/8” nc X 3”
hex bolt (#
16
) and the
3/8” nc
self-locking nut (#
22
).
(see sketch Q)
6)
Install the rubber bushing (#
1
), the
3/4” I.D. X 2” O.D. X 1/8”
flat
washer (#
25
), and the other rubber bushing (#
1
) over the
bushing spacer tube (#
2
).
7)
Install the
17mm I.D. X 50mm O.D. X 3mm
flat washer (#
26
) onto the
threaded part of the anti-rotation arm (#
10
).
8)
Screw the
5/8” nc
self-locking nut (#
23
) onto the threaded part of
the anti-rotation arm (#
10
). Do not overtighten.
NOTE :
Refer to the Track Kit manual to complete the
installation.
9)
Repeat
steps 1
to
8
for the opposite side.
sketch Q
6
22
10
16
sketch R
RIGHT
REAR VIEW
Rear of
the ATV
Rear of
the ATV
