11/11
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810413
A-2810413 Rev. A
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
375229
For Commander Wide Track, WTX, and TREX Track Kits
MOUNTING INSTRUCTIONS
11
MAIN AXLE ADAPTER INSTALLATION
(see sketch L)
WARNING :
Prior to installation, turn off the
engine, put in two-wheel driving mode, and
block the wheels.
1)
Raise the rear of the ATV off the ground and remove
the wheels.
WARNING :
When the ATV is raised, make sure
that it is properly secured/supported to prevent
it from accidentally falling during the installation.
If not properly secured/supported, serious
physical injury could occur.
2)
Install the
(4) M10-1.25 X 30 mm
hex bolts (#
21
) into the
threaded holes of the main axle adapter (#
20
) as
illustrated.
3)
Position and fasten the main axle adapter (#
20
) onto
the hub of the vehicle using the original wheel nuts.
Apply the tightening torque specified in your ATV
owner’s manual.
4)
Position and fasten the Track Kit to the main axle
adapter (#
20
) using the
(4) M10-1.25
wheel nuts (#
19
).
Torque to 25 ft-lbs.
NOTE:
16 wheel nuts M10-1.25 (#19) are included
in the kit, only 8 are needed for assembly.
NOTE:
Recheck torque of the wheel nuts (#19)
after one hour of use.
5)
Repeat
steps 2
to
4
for the opposite side.
sketch L
RIGHT
REAR VIEW
Rear of
the ATV
