6/12
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810417
A-2810417
ENSEMBLE DE SOUS-TABLES AVANT ET ARRIÈRE
Kimpex
#
375230
Pour ensembles de chenilles «Commander Wide Track» et «Commander Trek»
MOUNTING INSTRUCTIONS
6
MOUNTING
HOLE
Front of
the ATV
FRONT ANTI-ROTATION INSTALLATION
(see sketch E)
NOTE :
Pay special attention to the orientation given to spacers (#1 and #2) during installation.
1)
Assemble the ball joint (#
15
) and the
1/2” nf
nut (#
10
) to the front anti-rotation assembly (#
4
).
2)
Install the large ball joint spacer (#
1
) with the narrow part facing down onto the
1/2” nc X 2-1/2”
carriage bolt (#
9
) installed in
step 3 of
the “FRONT A-ARM BRACKET INSTALLATION” section.
3)
Install the ball joint (#
15
) of the anti-rotation assembly (#
4
) onto the bolt (#
9
), below the large ball joint spacer (#
1
). Install the short
ball joint spacer (#
2
) with the narrow part facing up, below the anti-rotation assembly (#
4
).
4)
Tighten the assembly with the
1/2” nc
self-locking nut (#
12
). Torque to 55 ft-lbs.
WARNING :
If the bolts are not sufficiently tightened, there is a risk of them becoming loose, of parts detaching and
risk of loss of control over the vehicle, as well as risk of personal injury.
5)
Rotate the anti-rotation assembly (#
4
) towards the center of the ATV to prevent it from interfering with the installation of the Track Kit.
NOTE :
Refer to the Track Kit manual to complete the installation.
6)
Repeat
steps 1
to
5
for the opposite side.
IMPORTANT :
Make sure to use the correct mounting hole on the anti-rotation (#4) when you assemble to the Track Kit
(see sketch E).
NOTE :
Under some conditions of use of the Track Kit, it is possible that the tracks come into contact with the footrests.
sketch E
LEFT
FRONT VIEW
