8/12
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810417
A-2810417
ENSEMBLE DE SOUS-TABLES AVANT ET ARRIÈRE
Kimpex
#
375230
Pour ensembles de chenilles «Commander Wide Track» et «Commander Trek»
MOUNTING INSTRUCTIONS
8
SNOWPLOW ADAPTER INSTALLATION (see sketch H)
WARNING :
Prior to installation, turn off the engine, put in two-
wheel driving mode and the transmission in neutral, and block the
wheels.
WARNING :
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally falling during the
installation. If not properly secured/supported, serious physical
injury could occur.
1)
Fasten the
(2)
rear anti-rotation arm supports (#
5
) onto the snowplow
adapter (#
20
) using
(6) 3/8” nc X 1-1/4”
hex bolts (#
10
) and
(6) 3/8” nc
self-locking
nuts (#
15
).
NOTE :
Refer to the snowplow adapter mounting instructions (no.
173247) to finish the installation.
• TO FINISH THE INSTALLATION OF “COMMANDER WIDE TRACK”
MODELS, SEE PAGES 8 TO 10.
• TO FINISH THE INSTALLATION OF “COMMANDER TREK” MODELS,
SEE PAGES 11 AND 12.
“COMMANDER WIDE TRACK”
REAR ANTI-ROTATION ARM BRACKET INSTALLATION (see sketch I)
1)
Remove the interior wheel of the tensioner. Refer to the Track Kit manual on section “
Wheels mounted on steel axles
”.
2)
Unscrew the self-locking nut (#
A
) from the 1/2” nc X 6” hex bolt (#
B
) retaining the wheel closer to the adjustment slide (#
C
). Remove
and discard the flat washer (#
D
).
(see sketch J)
3)
Assemble the rear right anti-rotation arm bracket (#
6
) to the hole made for this purpose in the plastic frame of the Track Kit using
(3) 3/8” nc X 3-1/2”
hex bolts (#
12
), a
3/8” I.D. X 1-1/4” O.D. X .120”
Fender washer (#
19
), the rear anti-rotation arm clamping plate (#
8
),
(3) 3/8”
nc self-locking nuts (#
15
), and the original self-locking nut (#
A
) removed in
step 1
.
4)
Reinstall the interior wheel of the tensioner. Refer to the Track Kit manual on section “
Wheels mounted on steel axles
”.
5)
Repeat
steps 1
to
4
for the opposite side.
sketch H
sketch I
RIGHT
REAR VIEW
Rear of
the ATV
sketch J
