2810324
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810324 Rév. A
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375117
FOR " COMMANDER WIDE TRACK " AND " COMMANDER TREK " / BRP OUTLANDER, OUTLANDER MAX
MOUNT PLATE INSTALLATION
WARNING:
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
WARNING:
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
NOTE:
If your vehicle have no rear protective plate, go
to step 3.
1)
Remove the original bolts (
F
) and nuts (
C
) retaining the bracket
(
E
) to the protective plate (
A
) (
see sketch G
).
2)
Remove the original bolts (
B
) and nuts (
D
) retaining the rear part
of the protective plate (
A
) to frame (
see sketch G
).
Do not discard. They will be reinstalled later.
3)
Fasten the rear part of the mount plate (#
8
) to frame using
(2)
3/8” nc X 1”
hex bolts (#
12
) and
(2) 3/8” nc
self-locking nuts (#
17
)
(screw the first threads only) (
see sketch H
).
4)
Fasten the front part of the mount plate (#
8
) to frame using the
mount plate support (#
10
),
(2) 3/8” nc X 1”
carriage bolts (#
15
),
and
(2) 3/8” nc
self-locking nuts (#
17
) (
see sketch I
).
5)
Secure all bolts and nuts.
t
TO FINISH THE INSTALLATION OF “COMMANDER
WIDE TRACK” MODELS, SEE PAGES 8 AND 9.
t
TO FINISH THE INSTALLATION OF “COMMANDER
TREK” MODELS, SEE PAGE 10.
sketch G
sketch I
sketch H
Front of the ATV
Front of the ATV
Front of the ATV
6/9
