6/8
ATV
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
2810408
A-2810408
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
#
374510
For Commander TREX UTV Track Kit
MOUNTING INSTRUCTIONS
6
FRONT ANTI-ROTATION INSTALLATION
(see sketch E)
NOTE :
Pay special attention to the orientation given to
spacers (#1 and #2) during installation.
1)
Assemble the ball joint (#
13
) and the
1/2” nf
nut (#
16
) to the front
anti-rotation assembly (#
7
).
2)
Install the large ball joint spacer (#
1
) with the narrow part facing
down onto the
1/2” nc X 2-3/4”
carriage bolt (#
14
) installed in
step
3 at the “FRONT A-ARM BRACKET INSTALLATION” section
.
3)
Install the ball joint of the anti-rotation assembly (#
13
) onto the
bolt (#
14
), below the large ball joint spacer (#
1
). Install the short
ball joint spacer (#
2
) with the narrow part facing up, below the
anti-rotation assembly (#
7
).
4)
Tighten the assembly with the
1/2” nc
self-locking nut (#
5
). Torque
to 65 ft-lbs.
WARNING :
If the bolts are not sufficiently tightened,
there is a risk of them becoming loose, of parts detaching
and risk of loss of control over the vehicle, as well as risk
of personal injury.
5)
Rotate the anti-rotation assembly (#
7
) towards the center of the
vehicle to prevent it from interfering with the installation of the
Track Kit.
NOTE :
Refer to the Track Kit manual to complete the
installation.
6)
Repeat
steps 1
to
5
for the opposite side.
IMPORTANT :
Make sure to use the correct mounting hole
on the anti-rotation (#7) when you assemble to the Track
Kit.
FRONT ANTI-ROTATION INSTALLATION
(see sketch F)
1)
Remove the wheel cap (#
A
).
2)
Assemble the free extremity of the front anti-rotation (#
7
) to the
hole made for this purpose in the frame of the Track Kit using the
3/8” nc X 4”
hex bolt (#
10
), the
3/8” dia (yellow zinc plated)
flat washer
(#
15
), the tightening spacer (#
3
), the neoprene flat washer (#
12
),
and the
3/8” nc
self-locking nut (#
18
).
Apply a tightening torque of 23 ft-lbs.
WARNING :
Attention, many holes are available on the
anti-rotation fixation plate. Take the one which will make
so that the track kit is correctly in contact with the ground.
3)
Reinstall the wheel cap (#
A
) removed in
step 1
.
4)
Repeat
steps 1
to
3
for the opposite side.
NOTE :
Refer to the Track Kit manual to complete the
installation.
sketch E
sketch F
LEFT
FRONT VIEW
LEFT
FRONT VIEW
Front of the ATV
Front of the ATV
