KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810202 (F-00)
2810202
5/7
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 373714
For "Commander" track kit / Yamaha Grizzly 2007
Front of the ATV
MOUNTING HOLE
FRONT ANTI-ROTATION INSTALLATION
(see sketch E)
NOTE :
Pay special attention to the orientation given to spacers (#4 and #5) during installation.
1)
Install the large ball joint spacer (#
5
) with the narrow part facing down onto the
1/2” nc X 2-1/2”
carriage bolt (#
10
) installed in
step 3 of
the “FRONT A-ARM BRACKET INSTALLATION” section.
2)
Install the ball joint of the front anti-rotation assembly (#
13
) onto the bolt (#
10
), below the large ball joint spacer (#
5
). Install the short
ball joint spacer (#
4
) with the narrow part facing up, below the anti-rotation assembly (#
13
).
3)
Tighten the assembly with the
1/2” nc
self-locking nut (#
9
). Torque to 55 ft-lbs.
WARNING :
If the bolts are not sufficiently tightened, there is a risk of them becoming loose, of parts detaching and risk
of loss of control over the vehicle, as well as risk of personal injury.
4)
Rotate the anti-rotation assembly (#
13
) towards the center of the ATV to prevent it from interfering with the installation of the Track Kit.
NOTE :
Refer to the Track Kit manual for the correct adjustment (section 3, page 17).
5)
Repeat
steps 1
to
4
for the opposite side.
IMPORTANT :
Make sure to use the correct mounting hole on the anti-rotation (#13) when you assemble to the Track
Kit (see sketch E).
sketch E
LEFT
FRONT VIEW
