Fix Kit And Replacement Parts Section - page 252

KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810202 (F-00)
2810202
4/7
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 373714
For "Commander" track kit / Yamaha Grizzly 2007
FRONT A-ARM BRACKET INSTALLATION
(see sketch C)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the front of the ATV off the ground and remove the
wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the A-arm
brackets. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the front left CV shield. Do not discard. They will be
reinstalled later.
3)
Insert the
1/2” nc X 2-1/2”
carriage bolt (#
10
) into the hole
intended in the front left A-arm bracket (#
1
).
4)
Install the front left A-arm bracket (#
1
) under the lower front
A-arm so that the two parts fit snugly.
5)
Install the
1/4” nc X 2”
U-bolt (#
16
) above the lower front A-arm
and fasten it to the A-arm bracket (#
1
) using a
1/4” dia
flat washer
(#
19
) and
(2) 1/4” nc
self-locking nuts (#
18
) (screw the first
threads only).
6)
Install the
5/16” nc X 2-1/4”
U-bolt (#
17
) above the lower front
A-arm and fasten it to the A-arm bracket (#
1
) using a
5/16” dia
flat
washer (#
14
) and
(2) 5/16” nc
self-locking nuts (#
3
) (screw the first
threads only).
(see sketch D)
7)
Install the front left A-arm clamping plate (#
2
) above the lower
front A-arm and fasten it to the A-arm bracket (#
1
) using
(3)
3/8” nc X 2-1/2”
hex bolts (#
15
) and
(3) 3/8” nc
self-locking nuts
(#
12
).
8)
Tighten all the bolts. Torque the
1/4” nc
nuts (#
18
) to 7 ft-lbs,
the
5/16” nc
nuts (#
3
) to 15 ft-lbs, and the
3/8” nc
nuts (#
12
) to
20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
9)
Repeat
steps 2
to
8
for the opposite side.
sketch C
LEFT
FRONT VIEW
LEFT
FRONT VIEW
Front of
the ATV
Front of
the ATV
sketch D
1...,242,243,244,245,246,247,248,249,250,251 253,254,255,256,257,258,259,260,261,262,...1407
Powered by FlippingBook