2810169
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810169 (F-00)
5/6
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 373010
FOR " COMMANDER " TRACK KIT / ARCTIC CAT 500, 650
ATV
REAR A-ARM BRACKET INSTALLATION
(see sketch C)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the rear left CV shield. Do not discard. They will be
reinstalled later.
3)
Install the rear left A-arm bracket (#
5
) under the lower front A-
arm so that the two parts fit snugly.
4)
Install the
1/4” nc X 2”
U-bolt (#
10
) over the lower rear A-arm into
the intended mounting holes of the rear A-arm bracket (#
5
).
Install the
1/4” dia
flat washer (#
15
) and the
(2) 1/4” nc
self-locking
nuts (#
12
) (screw the first threads only).
5)
Install the internal (#
6
) and external (#
7
) rear A-arm bracket
clamping plate over the lower rear A-arm and fasten it to the A-
arm bracket (#
5
) using the
(4) 3/8” nc X 2”
hex bolts (#
8
) and the
(4) 3/8” nc
self-locking nuts (#
13
).
6)
Tighten all the bolt. Torque the
3/8” nc
self-locking nuts (#
13
) to
20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
7)
Repeat
steps 2
to
6
for the opposite side.
sketch C
LEFT
REAR VIEW
Rear of the ATV
