2810169
KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810169 (F-00)
3/6
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 373010
FOR " COMMANDER " TRACK KIT / ARCTIC CAT 500, 650
ATV
FRONT A-ARM BRACKET INSTALLATION
(see sketch A)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the front of the ATV off the ground and remove the
wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the front left CV shield. Do not discard. They will be
reinstalled later.
3)
Insert the
1/2” nc X 2-1/2”
carriage bolt (#
11
) into the hole
intended in the front left A-arm bracket (#
5
).
4)
Install the front left A-arm bracket (#
5
) under the lower front
A-arm so that the two parts fit snugly.
NOTE :
The angled parts of the clamping plates (#6*,
one hole - Arctic Cat 500 model only) or (#7*, two holes
- Arctic Cat 650 model only) should mate the A-arm
bracket (#5) as well as possible.
5)
Install the front A-arm bracket clamping plate (#
6*, one hole -
Arctic Cat 500 model only
) or (#
7*, two holes - Arctic Cat
650 model only
) above the lower front A-arm and fasten it to
the A-arm bracket (#
5
) using
(1)
or
(2) 3/8” nc X 1-3/4”
hex bolts (#
8
)
and
(1)
or
(2) 3/8” nc
self-locking nuts (#
13
). Torque to 20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
6)
Repeat
steps 2
to
5
for the opposite side.
sketch A
LEFT
FRONT VIEW
Front of the ATV
