KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810323 Rév. A
2810323
5/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375417
For "Commander Wide Track" and "Commander Trek" track kit
2009-2010 Polaris Sportsman XP
Front of the ATV
FRONT A-ARM BRACKET INSTALLATION
(see sketch E)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the front of the ATV off the ground and remove the
wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the front left CV shield. Do not discard. They will be
reinstalled later.
3)
Insert the
1/2” nc X 2-1/2”
carriage bolt (#
11
) into the hole
intended in the front left A-arm bracket (#
8
).
4)
Install the front left A-arm bracket (#
8
) under the lower front
a-arm so that the two parts fit snugly.
5)
Install the front left A-arm clamping plate (#
6
) above the lower
front a-arm and fasten it to the A-arm bracket (#
8
) using the
(4)
5/16” nc X 2-1/4”
carriage bolts (#
10
) and the
(4) 5/16” nc
self-locking
nuts (#
14
). Tighten the bolts and make sure they fit snugly.
Torque to 20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
6)
Repeat
steps 2
to
5
for the opposite side.
sketch E
LEFT
FRONT VIEW
