KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810287 Rév. A
2810287
8/9
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375416
For "Commander Wide Track" and "Commander Trek" track kit
2009 Polaris Sportsman XP
Rear of the ATV
REAR A-ARM BRACKET INSTALLATION
(see sketch H)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the rear left CV shield. Do not discard. They will be
reinstalled later.
3)
Place the rear left A-arm bracket (#
9
) below the rear lower a-arm
and fasten the exterior part of the A-arm bracket using the large
rear A-arm clamping plate (square holes) (#
8
),
(2) 3/8” nc X 2-1/4”
carriage bolts (#
12
), and
(2) 3/8” nc
self-locking nuts (#
15
) (screw
the first threads only).
4)
Fasten the interior part of the A-arm bracket (#
9
) to the rear
lower a-arm using the short rear A-arm clamping plate (round
holes) (#
7
),
(2) 3/8” nc X 2-1/4”
carriage bolts (#
12
), and
(2) 3/8” nc
self-locking nuts (#
15
) (screw the first threads only).
5)
Tighten the bolts and torque to 25 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly
sketch H
LEFT
REAR VIEW
