KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810260
2810260
8/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375415
For "Commander Wide Track" and "Commander Trek" track kit
Polaris Sportsman X2 touring
Rear of
the ATV
REAR A-ARM BRACKET INSTALLATION
2007 SPORTSMAN X2 MODEL
(see sketch F)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the A-arm
brackets. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the rear left CV shield. Do not discard. They will be
reinstalled later.
3)
Install the rear left A-arm bracket (#
1
) under the lower rear
A-arm so that the two parts fit snugly.
4)
Install the rear left A-arm clamping plate (#
2
) above the lower
rear A-arm and fasten it to the A-arm bracket (#
1
) using the
(4)
3/8” nc X 2-1/4”
hex bolts (#
6
) and the
(4) 3/8” nc
self-locking nuts
(#
7
). Torque to 20 ft-lbs.
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
5)
Repeat
steps 1
to
4
for the opposite side.
6)
Go to
“REAR ANTI-ROTATION INSTALLATION”
section
(page 9) for the next steps.
sketch F
LEFT
REAR
VIEW (2007 SPORTSMAN X2 MODEL)
