KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810260
2810260
7/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375415
For "Commander Wide Track" and "Commander Trek" track kit
Polaris Sportsman X2 touring
sketch F
FRONT ANTI-ROTATION INSTALLATION
(see sketch F)
NOTE :
Pay special attention to the orientation given to
spacers (#11 and #12) during installation.
1)
Assemble the ball joint (#
20
) and the
1/2” nf
nut (#
19
) to the
front anti-rotation assembly (#
18
)
.
2)
Install the large ball joint spacer (#
12
) with the narrow part facing
down onto the
1/2” nc X 2-1/2”
carriage bolt (#
16
) installed in
step
3 at the “FRONT A-ARM BRACKET INSTALLATION” section
.
3)
Install the ball joint of the anti-rotation assembly (#
20
) onto the
bolt (#
16
), below the large ball joint spacer (#
12
).
Install the short ball joint spacer (#
11
) with the narrow part
facing up, below the anti-rotation assembly (#
18
).
4)
Tighten the assembly with the
1/2” nc
self-locking nut (#
15
).
Torque to 65 ft-lbs.
WARNING :
If the bolts are not sufficiently tightened,
there is a risk of them becoming loose, of parts detaching
and risk of loss of control over the vehicle, as well as risk
of personal injury.
5)
Rotate the anti-rotation assembly (#
18
) towards the center of
the ATV to prevent it from interfering with the installation of the
Track Kit.
NOTE :
Refer to the Track Kit manual for the correct
adjustment.
6)
Repeat
steps 1
to
5
for the opposite side.
IMPORTANT :
Make sure to use the correct mounting
hole on the anti-rotation (#10) when you assemble to
the Track Kit (see sketch F).
MAIN AXLE ADAPTER INSTALLATION (see sketch G)
1)
Remove and discard only one bolt retaining the sprocket to the
main axle of the track kit.
NOTE :
Pay special attention to the orientation given to
the main axle adapter (#4) during installation. The lip, of
the main axle adapter, must fit perfectly the circumfer-
ence of the main axle.
2)
Position the main axle adapter (#
4
) and fasten using the
(2) 3/8” nc X 2-1/4”
Allen socket machine screws (#
10
).
Torque to 20 ft-lbs.
3)
Install the Track Kit onto the hub of the ATV using the
(4) 3/8” nc
“T” nuts (#
3
). Torque to 25 ft-lbs.
NOTE :
Recheck torque of the “T” nuts (#3) after one
hour of use.
4)
Repeat
steps 1
to
3
for the opposite side.
sketch G
LEFT
FRONT
VIEW
Front of
the ATV
MOUNTING
HOLE
