KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810253
2810253
8/9
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375317
For "Commander Wide Track" and "Commander Trek" track kit
Kawasaki brute force KVF 750
REAR A-ARM BRACKET INSTALLATION
(see sketch H)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the sub-
tables. If not properly secured/supported, serious
physical injury could occur.
2)
Remove the rear left CV shield. Do not discard. They will be
reinstalled later.
3)
Place the rear A-arm bracket (#
1
) below the rear lower A-arm so
that the two parts fit snugly.
4)
Install the rear A-arm clamping plate (#
14
) over the rear lower
A-arm and fasten it to the A-arm bracket (#
1
) using the
(4)
3/8” nc X 2-1/2”
hex bolts (#
15
) and the
(4) 3/8” nc
self-locking nuts
(#
2
).
Torque to 20 ft-lbs
IMPORTANT :
Tighten in a manner not to permanently
deform the assembly.
5)
Repeat
steps 2
to
4
for the opposite side.
MAIN AXLE SHIMS INSTALLATION
(see sketch I)
1)
Remove the original wheel studs from the hub of the ATV.
2)
Insert the
(4) M10 X 35mm
wheel studs (#
17
) and position the
(4)
shims (#
16
) onto the hub of the ATV.
3)
Install the Track Kit onto the hub of the ATV using the
(4) M10
wheel nuts (#
18
). Torque to 25 ft-lbs.
NOTE :
Recheck torque of the wheel nuts (#18) after
one hour of use.
4)
Repeat
steps 1
to
3
for the opposite side.
sketch H
sketch I
LEFT
REAR VIEW
Rear of
the ATV
