KIMPEX INC.
/ 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA
/ 100 Walnut Street / Champlain, New York / 12919
Lithographié au Canada / Litho’d in Canada
A-2810336
2810336
8/11
ATV
MOUNTING INSTRUCTIONS
FRONT AND REAR A-ARM BRACKET KIT
Kimpex
# 375315
For "Commander Wide Track" and "Commander Trek" track kit
2002-2004 Kawasaki brute force KVF 650 / 2004-2006 Kawasaki brute force KVF 700
Rear of
the ATV
“COMMANDER WIDE TRACK”
REAR ANTI-ROTATION ARM BRACKET
INSTALLATION (see sketch K)
1)
Remove the interior wheel of the tensioner. Refer to the Track Kit
manual on section “
Wheels mounted on steel axles
”.
2)
Unscrew the self-locking nut (#
A
) from the 1/2” nc X 6” hex bolt
(#
B
) retaining the wheel closer to the adjustment slide (#
C
).
Remove and discard the flat washer (#
D
).
(see sketch L)
3)
Assemble the rear right anti-rotation arm bracket (#
4
) to the hole
made for this purpose in the plastic frame of the Track Kit using
(3) 3/8” nc X 3-1/2”
hex bolts (#
12
), a
3/8” I.D. X 1-1/4” O.D. X .120”
Fender washer (#
19
), the rear anti-rotation arm clamping plate
(#
6
),
(3) 3/8”
nc self-locking nuts (#
15
), and the original self-
locking nut (#
A
) removed in
step 1
.
4)
Reinstall the interior wheel of the tensioner. Refer to the Track Kit
manual on section “
Wheels mounted on steel axles
”.
5)
Repeat
steps 1
to
4
for the opposite side.
“COMMANDER WIDE TRACK”À
MAIN AXLE ADAPTER INSTALLATION
(see sketch M)
WARNING :
Prior to installation, turn off the engine, put
in two-wheel driving mode and the transmission in
neutral, and block the wheels.
1)
Raise the rear of the ATV off the ground and remove the wheels.
WARNING :
When the ATV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation. If not properly
secured/supported, serious physical injury could occur.
2)
Remove the rear right CV shield. Do not discard. They will be
reinstalled later.
3)
Install the
(4) M10 X 25mm
hex bolts (#
9
) into the threaded holes
of the main axle adapter (#
8
) as illustrated.
4)
Position and fasten the main axle adapter (#
8
) onto the hub of
the vehicle using the original wheel nuts. Apply the tightening
torque specified in your ATV owner’s manual.
5)
Position and fasten the Track Kit to the main axle adapter (#
8
)
using the
(4) M10
wheel nuts (#
14
).
Torque to 25 ft-lbs.
NOTE :
Recheck torque of the wheel nuts (#14) after
one hour of use.
6)
Repeat
steps 2
to
5
for the opposite side.
sketch K
sketch L
sketch M
RIGHT
REAR VIEW
RIGHT
REAR VIEW
Rear of
the ATV
